Results 1 to 5 of 5

Thread: Marble Board

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Join Date
    Aug 2008
    Location
    Manchaca, (Austin) TX
    Posts
    1

    Default Marble Board

    I did this project to learn“snap to grid” (marble holes) & “mirror all” (stars). I used the basic Project Designer using the supplied bits & 1/2”Classical. The first one was round and the holes were “1/2circles” then “carve region.” To better show the capabilities of the CW, this one was changed from round to a six sided, also I used 3d “puffing” instead of basic “carve.”

    Cut into 7” walnut it took the CW a hour & 45 mins at the best setting. I just carved this on 3 June after deciding to enter your contest. Should I enter this“as is” to show how well the machine carves? Or sand with the mop and apply a finish, to show how good I am at finishing?

    Gary Bagby in Austin, Texas
    Attached Thumbnails Attached Thumbnails IMG_9764.JPG   IMG_9762.JPG  

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •