I need a replacement belt (X-Drive Conveyor Belt) any ideas of where I can purchase one?? Carvewright is asking $134.00 for the belt and assembly, I just need a belt. Thanks
I need a replacement belt (X-Drive Conveyor Belt) any ideas of where I can purchase one?? Carvewright is asking $134.00 for the belt and assembly, I just need a belt. Thanks
The sandpaper belts alone are only $16.50 if that is what your looking for?
http://store.carvewright.com/product...id=16150&cat=0
Did you understand why the belt broke? Tapered Wood, Rolled Under Belt, Wood installed on a Angle....
Normally you just replace the belt... Did a drive gear snap?
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Hi Al, I have not checked that part out yet, I hope not. Thanks for the reponse guys.
I checked the drive gear and it is ok. I was not operating the machine at the time but I beleive the board may have been on top of the adjustable slide bar that hold the wood in place. Thanks again
Last edited by deron; 05-29-2013 at 09:46 AM.