Hello all, Finally got my new machine up and running. Everything has been pretty good so far but I'm having one small issue:

When I insert a new board and perform a measurement, it is nearly perfect. In this case, a brand new piece of MDF that is 8" by 15.5". The length is dead on and the width measures at 8.018" which I thought was pretty good and doesn't require recalibration.

I then ran a measurement with a bigger board, 10 by 36" and it provided similar accuracy.

Back to the original test board, re-measurement looks good again. Go to start project, and when it measures at the start, it comes up with 8.443"! So it wants to center on width or insert a new board. If I select center on width, it is making my text letters way smaller than intended.

Any help would be appreciated. I don't understand how the machine is coming up with different measurements for the same exact workpiece, especially when leaving it in place and not removing it between measurements.

This is 3/4" MDF that I cut on my table saw which is pretty well calibrated.

Thanks in advance!