Originally Posted by
bergerud
What does the machine do if you press stop or lift the cover while the bit is under? Does it move the bit back to the hole before lifting or does it not lift?
LOL...bergerud, you never let me down.
Short answer is: DON'T DO IT.
Long answer is: The bit should wind down and come to a stop without it being an issue, but there are several factors involved and it is not suggested that you test it.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!