convert to dxf

[Cabinetdesigner]

would anyone be willing to convert this to a dxf for me.

[lawrence]

sure... just a min

[lawrence]

I wasn't sure whether you wanted the actual DXF or an MPC made from the dxf so I made both for ya.

I also turned it on its side for the MPC so that it would more naturally fit onto most boards- let me know if this
isn't what you were looking to do.

I hope this helps,
Lawrence

[Cabinetdesigner]

thanks what I am going to attempt to do is cut this out of a piece of 1/4".