I was thinking of this recent post, regarding the copy/paste/flip/join:
http://forum.carvewright.com/showthr...355#post202355
I was thinking of this recent post, regarding the copy/paste/flip/join:
http://forum.carvewright.com/showthr...355#post202355
Michael T
Happy Carving!
╔═══ Links to Patterns & Resources for CompuCarve™ & CarveWright™ ═══╗
I did the copy, paste and flip,only in doing so the pattern had distorted, like the one in the tutorial, thought I go back and see how to straiten it out..
I tried again with no success I'm thinking that it is welded but its not allowing the cutout to light up
I tried it and it worked fine for me. Do you have the snap to grid on?
I have the snap to grid on to no avail is the cutout lighting up.
Okay, 1st of all the right side is a mirror and 2nd you have a 2-rail sweep applied. You can't join the two halves together in either of these cases. I fixed it by removing the 2-rail sweep and then deleted the mirror. Copied and pasted the left side and then flipped it horizontally and re-positioned it on the right side. Then I re-applied the 2-rail sweep. Next I pasted the left side in again and deleted the two end vertices at the top and bottom. Copied, Pasted and flipped again. moved the copy to the right side and joined the two halves with straight lines. I used this shape for the cutout.
Last edited by SteveNelson46; 04-23-2013 at 01:39 PM.
Steve
I Have'nt got it yet but I'm getting closer. thanks guys, I'll try agian tommorrow.
Michael T
Happy Carving!
╔═══ Links to Patterns & Resources for CompuCarve™ & CarveWright™ ═══╗