I don't know if this is true or not but when I get the z axis error I adjust the carving bit a little longer and it seems to fix the stall go figuar..... Maybe the newer versions are set for the new adapter .
Junior Member
I don't know if this is true or not but when I get the z axis error I adjust the carving bit a little longer and it seems to fix the stall go figuar..... Maybe the newer versions are set for the new adapter .
http://william.bowen.com/:)
("There is a principle which is a bar against all information, which is proof against all arguments and which cannot fail to keep a man in everlasting ignorance-that principle is contempt prior to investigation."
- Herbert Spencer )
Senior Member
If the z moves easily, the FFC ribbon is not the problem, and it stalls right away, I would suspect the encoder disk in the back of the z motor. Maybe it is spinning freely or dusty.
Junior Member
im trying to upload a video now!
Senior Member
Originally Posted by bergerud
Ding Ding ding.... We have a Winner !!!!
Good Job !!!!
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Senior Member
Thanks AL. It is fun to be right once in awhile!
Posting Permissions
Reply With Quote