The cut motor stopped in the middle of a project; I only have 40 hours on the machine and less than 25 on the cut motor. The error was something about an axis (sorry I did not write it down), so I cleaned and oiled everything again, because I had just done the 25 hour maintenance before my last project that turned out fine.
I tried to start the project again and the machine proceeded to go through the process of carving the project; only the cut motor was not running. All the axis were going through the motions, but the motor was silent.
When I test the cut motor in the options menu it say the cut motor is running, but the machine is doing nothing. If I lift the cover during this test the motor makes a slight "chunk" sound. It makes the sound again when I close the cover and press a key. I also check the sensor and the rpm counted up: 1,2,3 as I turned the bit.
Please help.