ER20 Spindles need to know if theres any interest ...

[bergerud]

I only had 10. I will add you to my list. There may be one left or I may get more.

[ekimnamyr]

Thanks much, I appreciate that. Mike;

[ktjwilliams]

OK Dan, I'm not seeing much on the feed back on the spindle .. I had mine installed and running in bout ten minutes ... Since I have been using these for some time now, I already had the collets maybe that's what folks are waiting for ... In any case this one runs great and I was saved the trouble of making it myself like we have done in the past.. I have one more machine to add this to and all my machines will have either an ER 11 or ER 20 ... If you get more I am interested ... Like I said I have one more machine that I would convert over... And Thx much for doing this for us ... These things are great !!!!

[bergerud]

Has anyone else had a chance to install and test the spindle? I expect reports! Are you all just waiting for collets?

[unitedcases]

Waiting for collets here. The user tests were promising. Sounded good.

[earlyrider]

Have collets in hand now. Just need to put z truck in working machine. Should have something to report this next week.

[RogerB]

Sorry just have not had time. Will try soon I hope.

[blhutchens]

http://www.ebay.com/itm/New-1pcs-1-2...item41756bc469

will this work for keeping CT in tact and just using it for small bits.

[chief2007]

http://www.ebay.com/itm/New-1pcs-1-2...item41756bc469

will this work for keeping CT in tact and just using it for small bits.

Yes that is what I use with my Carvetight and it works great. I purchased several so I do not have to change the bits during use. Have the preloaded before the project starts. No problems at all and I have at least 150 carvings hours using them.

[blhutchens]

thanks, I thought they would work just wanted to make sure before I bought em.