Cursive Name Cutout Help

[doublejz]

I made the scallops all one curve and made it a cut path. I moved it up a little. You may want to move it. If you do move it, the cut may disappear if the end points are not on or over the ends of the board. Good luck. I know, there is a lot to learn.

Thanks. I still cannot figure out how you took the individual arcs and connected them all together to make one solid curve.

[bergerud]

Page 56 in the software manual.

http://www.carvewright.com/assets/se...are_Manual.pdf

[doublejz]

Just wanted to show my progress on this today.

[badbert]

Excellent progress! And a beautiful project. She will cherish it forever.

[easybuilt]

That came out awesome!

[doublejz]

I made the scallops all one curve and made it a cut path. I moved it up a little. You may want to move it. If you do move it, the cut may disappear if the end points are not on or over the ends of the board. Good luck. I know, there is a lot to learn.

bergerud, do you remember what font this was that you/we went with? I would like to cut something else out very similar but I can't find the font we used before we setup the cut paths?

I tried to cheat and just take the letters from the old project but I was missing letters that I need to complete the name

[lynnfrwd]

That looks like Stencil Font

[doublejz]

That looks like Stencil Font

I kind of thought that originally too. The top one is Stencil the bottom one was the previous project.

[lynnfrwd]

There are 139 different free stencil font types on 1001fonts.com

[lynnfrwd]

I think I found it...http://www.dafont.com/pencil-stencil.font
Pencil Stencil.