Got my 2 I ordered Fri they look good used one Sat and works great I already had 1 I bought with 6 collets a wrench and nice box from issacr had to cut it myself cost was $317 plus tax!
I just ordered 2. Estimated arrival is 30-Sep. Now if I wasn't so deep in another project I could get back to my CarveWright. Withdrawal is horrible.
Hopefully yours come in sooner than mine. I ordered one on August 8th and they arrived yesterday. He kept telling me they were shipped and then said he we going to send another but I only received one via wagon train I think??
Tom Watson
Two CW's and D.C.-Top Mount Insert @ Ringneckblues.com Get the dust out!!
50" X 48" PDJ Pilot Pro CNC http://www.pdjinc.com
Check out my Facebook page for current carvings at http://www.facebook.com/signsinwood
Watsons Wooden Words http://www.signsinwood.com & Messages in Wood http://www.messagesinwood.com/
Average fas been 3-4 weeks, I think clearing US Customs may be be part of the delay.
Good move to get at least 2. I purchased a 3rd.
Now who has links for 3/16 carving (ball nose) bits from a different source? The 3/16 cutting bit is not a problem to find.
I haven't got the spanner wrench yet, I got the collets and the spanner wrench wasn't sent with them I am still waiting on the wrench did a tracking on it and its in Chicago via ups I did use the 1/4 collet used a universal spanner wench didn't get the collet tight enough and it slipped out good thing I was close to it, it tore the rubber belt a little but it's still good...still waiting to get it I was one of the first ones to order the er-11.. I been waiting for about 6 or 7 weeks on getting the complete package but he has made good on his word. Tom China's a long ways from here still waiting for the wagon train to get here....
Last edited by aokweld101; 09-22-2013 at 08:30 AM.
I do not have a Rock to test. I have used the ER11 adapters on an ER20 which was as low as the Rock. The only potential problem I can see is if you put a really short bit in it and carved a deep hole. If you really try, it is possible to drive the ER nut into the wood. (This cannot happen with the CT.)
So, I think that they would work just fine with the Rock.
Last edited by bergerud; 09-22-2013 at 11:59 AM.
Thanks Bergerud