The CT chuck is nearly 1/2 inch higher than the other chucks. This extra space was what I used to slip the dust shoe between the chuck and the board. Well, I just found another use for the space: an ER11 adapter. I just made one out of an old ER11 spindle that I had laying around. It is very simple to make from a cheap Chinese ER11 collet extension (pictured in the background). The neat thing about it is that you clamp it onto a bit and then put it in the CT chuck. It is a variable size adapter. It will hold any size bit from 1/32 to 1/4. I have not had a chance to test it yet but I will this weekend on my friends C machine. I do not think it will run as true as a full ER spindle. But think of the possibilities!
EDIT: From later on in this thread (post 86). ER11M adapters made in China on ebay at: http://www.ebay.com/itm/New-1pcs-1-2...item41756bc469