VectorArt3D Patterns

[Rickrljones]

I just carved a pattern from VA3D, tryed to increase the depth of carve, on a recessed model and Designer told the CW to carve a feathered edge instead of a dished pattern... The default depth is 1/4". Has any one else run accross problem, if so ideals on how to correct this.
Thanks

[HandTurnedMaple]

I was able to duplicate that with the free FDL dish pattern. Try setting either your depth to .125 or your height to 200.

[Rickrljones]

Will give a try, thanks for the advise

[HandTurnedMaple]

I may not have answered this correctly. The answer you probably want is to turn off feather setting in Designer. It tends to default to 1/4" feather. But I only buy the normal VA patterns and tell it to recess if that's the look I want.

[Rickrljones]

What is the free FDL Pattern

[HandTurnedMaple]

VA3D has a free flower thing and a fleur-de-lis (or however you spell it).

[pkunk]

here http://www.carvewright.com/forum/viewtopic.php?t=336