Results 1 to 2 of 2

Thread: Help needed in Seattle, Wa.

  1. #1
    Join Date
    May 2010
    Location
    Arlington, TX
    Posts
    19

    Default Help needed in Seattle, Wa.

    I recently sent my father-in-law a cutting board in Seattle. It turned out well, with one minor problem. I measured only once it would seem, it's approx. an inch to wide. I was hoping to enlist someone close by to trim each side by a half inch. Of course I would compensate the carver accordingly. Just don't want my father to bother with sending it back. Look forward to a positive response


    Regards, Doc
    Attached Thumbnails Attached Thumbnails ImageUploadedByTapatalk HD1360554821.930078.jpg  
    Regards,
    Doc

  2. #2
    Join Date
    Jan 2009
    Location
    Bonney Lake, Washington, United States, 113160055365328, Bonney Lake, Washington
    Posts
    1,803

    Default

    Where is he in Seattle, I am in Bonney lake? Send me an email I may be able to help. easybuilt@comcast.net
    Tom Watson
    Two CW's and D.C.-Top Mount Insert @ Ringneckblues.com Get the dust out!!
    50" X 48" PDJ Pilot Pro CNC http://www.pdjinc.com

    Check out my Facebook page for current carvings at http://www.facebook.com/signsinwood

    Watsons Wooden Words http://www.signsinwood.com & Messages in Wood http://www.messagesinwood.com/

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •