Not sure where to find if its here but when carving the pattern ends up having areas that either carved to deep or not enough through out the carve anyone have any ideas? Maybe compression issue?
Not sure where to find if its here but when carving the pattern ends up having areas that either carved to deep or not enough through out the carve anyone have any ideas? Maybe compression issue?
Post a picture of you carve so that we can get a better idea of what your talking about.
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
Its in the middle of the shield this one isnt to bad but sometimes its alot worse....Attachment 0
Its not carving evenly in some places....
Un even carving areas like this is usually because the head is being raised up as the dust that is built up on the board goes under the compression rollers. If the inside of the ends of the rollers has dust built up it does not allow enough movement for the roller to raise up enough and will cause the head to raise instead.
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
What about the z encoder?
Sent from my ADR6300 using Tapatalk 2
Custom Stadium Coin Racks for displaying Military Challenge Coins, GeoCoins and the like- http://www.etsy.com/shop/stadiumdisplays
OR http://shop.ebay.com/stadiumdisplays...&_trksid=p4340
Are you using a sled or a board that is 7 inches longer than your project?
I think it is the mpc. The deeper carves are only in the background, not across the whole carve. You really should post the mpc.