My problem from a couple weeks ago was resolved with a new Xterm board....This is NEW.
Ran 2 projects (9 hours) after the xboard was changed, all good.
Now, the spindle turns for half a second when the main machine power is turned on (on/off switch on keyboard side of machine). Shut it off & turn it on, does it every time !!
If you continue through the setup, everything spins & runs fine...for about 5 minutes !!! Then, the truck raises, machine stops, and the screen reads to close the cover. I have bypassed the cover switches for testing purposes, and this has not helped.
Ideas appreciated, as we have 2 more awards to cut for a national dog show in March.
Brad