back to the new machine

[chief2007]

Didn't see anything on the project file that would have caused an error. Not even the spelling, lol

Sometimes a fluke on nature. Have you tried carving another project? This is a new Version C machine correct?

[RogerB]

Do you have 1/2 on each side of the carve

[woodchip]

Not yet, will try tomorrow. do you mean 1/2 inchfrom the edge? I did by the way vacume the dust but it started right away.

[woodchip]

Just a follow up, 2 machines up and running.... need more lumber lol
Thanks all
Don

[chief2007]

Just a follow up, 2 machines up and running.... need more lumber lol
Thanks all
Don

What did you find out on machine 2?

[woodchip]

the new machine had a burr on the rail the y traveled. the old one neededto be unlocked.
thanks again
Don

[carrothers]

The first thing I noticed when I pulled up your mpc file was the dimensions of your board vrs. the pattern. I always put in 3.5 inches on each end and at least a half inch on the width. That being said you might be planning on putting it on a sled so you can carve it out as you laid it; however I think the sled has to have the dimensions of the sled as the "board settings"...but I could be wrong. I try to avoid using sleds if at all possible.

[henry1]

the new machine had a burr on the rail the y traveled. the old one neededto be unlocked.
thanks again
Don

Glad to see your running ok, your poject turn out ok