Getting even closer to finishing the CID badge. Need to fix a few areas in PE after importing the STL file.
Getting even closer to finishing the CID badge. Need to fix a few areas in PE after importing the STL file.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
What a wonderful pattern on the badge Eddie.
You really do a fine job with all your patterns,
I for sure know that since I have carved some of them.
Happy Carving
Robert D.
rcdages
CarveWright START U Team Member.
The mightiest oak in the forest is just a little nut
that held it's ground.
Great job Eddie! I see you are still learning and improving with your 3d & 2.5d modelling skills! Keep it up! I still read a lot on this forum, but I don't say to much these days. Just wanted to take a moment and say "Hi".
Doug Fletcher
Thanks Robert and Doug (I see you once in awhile Doug, nice to see you around at times).
Here is the final, and will be on my site later today. Have to go out to a job right now.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
The CID badge is now on my site.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Looks really great Ed! I will be purchasing it soon!
Kevin
Thanks Kevin, check you PM. size is 16.9x13.8x.6 (rotate it 90 deg to get full size)
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Take a bow Ed! That came out beautiful!! I could never make that!
"Carved with Love"
Happiness comes from within.
But joy comes from helping others.
Measure twice... and then sneak up on it!