Does anyone know if the memory card will work on any machine? Looking at purchasing another machine, Just wondering if a design on one card can be put in either machine?
Does anyone know if the memory card will work on any machine? Looking at purchasing another machine, Just wondering if a design on one card can be put in either machine?
Yes, it will work on any CW. I've got 4 cards that I use between 2 machines.
JerryB:.
CarveWright START U Team Member
Using 1.187, Conform, PE/Probe, Centerline.
"Let's start sharing PTNs instead of MPCs so ALL SW versions can view & share"
Some put a strip of Tape on the card to stick out the end to act as a Handle to make it easier to pull out.
The Card will have the Operating System on it that operates the machine and normally matches your designer version or it will ask you to upgrade it.
WELCOME !!!!
Find Tips and Tricks on the LHR page and read them. Lots of Good to know info like the 7 inch rule of wood, scaling and MORE.... Helps Prevent Pilot Error and making expensive fire wood....
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Thanks Guys. The tape idea is good!! that little card fits tight!