Live to ride

[bergerud]

No, I just found it in my downloaded archive. (Someone collected all of the patterns from the forum and posted a zip file a few years ago. Anyone remember who that was?)

[CarverJerry]

I got the same zip file too but don't remember who it was. I have a bunch of HD patterns also.

[fwharris]

No, I just found it in my downloaded archive. (Someone collected all of the patterns from the forum and posted a zip file a few years ago. Anyone remember who that was?)

Jason Allen, LittleRedWoodShop

[bergerud]

Jason Allen, LittleRedWoodShop

Ah yes. I guess that download link is long gone.

[gwhiz]

Thank you! I added "draft" and it looks exactly what I am looking for....thank you again!

Yep--that's the one. I carved it with Medium draft. Show us the final result!

[fwharris]

Ah yes. I guess that download link is long gone.

I went through my old favorites link and could not find it. I did find my downloaded zip file though, forum downloads

[AlBCuttnWud]

First run through didn't go as well as I would have liked. The center part text "Harley Davidson" is barely readable. I used the following settings: .250 depth, 100 height, medium draft, 1/16" bit set on best setting.

Not sure if there is a better pattern that what I used or anyway I can this one can be manipulated so the text is better.....thoughts?

[bergerud]

I noticed that the text did not look good with bit optimization best. Maybe bit optimization should be off?

[Proctorw]

try 999 height. Height is a relative measurement and is set from the lowest point of the board upward. to get it to the top, use 999. I have found 999 fixes most issue with depth.

[AlBCuttnWud]

I noticed that the text did not look good with bit optimization best. Maybe bit optimization should be off?

That seems to look much better. I'll give it a try.....thank you.