I haven't carved this yet but, I sure had fun designing it.
I haven't carved this yet but, I sure had fun designing it.
Last edited by SteveNelson46; 01-01-2013 at 07:58 PM.
Steve
Looks great Steve
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Very nice work with the design!
Looks great, Steve. Thanks for sharing.
Capt Barry
great looking design-- it would look amazing in mesquite
Lawrence
Looks good. Now you need a 2 layer thick little bowl to put in the center for the dip.
Clint
That's cool... is it just in 3/4" material or what?
dehrich
Yes! the material thickness is .75" and the outside diameter is 13.5". I plan to glue up a 21" by 14.5" blank today and carve it tomorrow. Well, maybe I'll carve it the day after tomorrow. I'm having a tooth extracted and prepared for an implant tomorrow. I will post pictures when it's done.
Steve