Ok I finally figured out it was my machine and not the mpc or puffing that was causing the problems. So here is the Shoe Top. I made the hole in the top larger for the Rock. If you carve it as a double sided carve, you will have some large tabs to cut. You can split it into to single carves. (That is what I do.) Remember to touch where the bearing hole will be on the bottom side and then for the top, touch on the carrier board (or somewhere which is 1/2 inch from the back.)
I made a little cup for the earlier CT version which fits in the hole and holds the window down lower. I do not know, however, how close the Rock comes to the board. I need to know the total length of the Rock (without adapter) below the truck bearing as well as the dimensions the part of the adapter which sticks out. There may be a problem with the cup if it has to be too deep. Only a small ring gap will be left for the chips and longer, stringy chips may plug it up. In any case a shallow cup which easily pops in and out would probably be ok for Rock users.
Last edited by bergerud; 01-31-2013 at 09:39 PM. Reason: Removed 3D tilt
Last edited by henry1; 01-31-2013 at 08:56 PM.
Henry
Every one has a photographic memory. Some just don't have film.
Yes Henry, the Shoe cap fits on the body you have already carved.
Thank you Dan i look forward to carving tomorrow
Thank YOU for the Rock Files. The last one I was confused until I looked on the back of the board... Nice Work !!!!
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Henry
Every one has a photographic memory. Some just don't have film.