cut motor
I wrote on a ploblem I thought was a was a ploblem, this morning.... after I put my bushings in the cut motor last night I did the sensor check and the cut motor come on, thought things were OK went to do a crarve this mornging it went through it's cycles when the cut motor was to start, it did'nt come on, it started to drag the the bit... after talking to someone, and I thought about what i did, I was making the cookie box and in the article it said to keep it under rollers.my board lenth was under by 1/16 and I heard that it sized it to the board length, when its under the rollers.. so I cut the board to size and pressed to keep under rollers and the motor and the carve went without a ploblem.I think the best thing that I can say is..... it's the simple things that make it so hard ...
Reply With Quote
