Boy am I having to do maintenance on my new C model. Have about 21 hours on it now. the motor stopped spinning during a carve. So all looked good and inserted anather board. Worked for 3 minutes and got a check cut motor.
Took the machine bottom off and checked all connections, cleaned. Looks good.
-powered on and tried the board, but it just dragged the bit across the board with no error. Was no spinning.
-tried the cut motor test and it said it was running, but the bit is not turning.
-checked cable several times and it spins fine and you can see the motor turning when I move the bit by hand.
-checked cover switch with meter, shorts fine when closed.
-took off top and cleaned any thing that I could.
-same problem. When I do a cut motor test it just does nothing, and says it is turning. No errors.
-I have not re-seated any jacks on the back board as they look epoxied in place.
Any ideas?
Carvewright A machine 2007
Carvewright C machine 2013 DC-Insert
Mavric iMac i7 16gig latest version
Designer 1.187, Designer 2.04, Centerline Text, Conforming Vectors, STL importer, DFX importer, Pattern Editor and probe