Ordered my machine today. Planning on breaking lots of things and making lots of firewood! I am concerned about running through knots on cedar. Thoughts, suggestions....?
Thanks,
Paul
Ordered my machine today. Planning on breaking lots of things and making lots of firewood! I am concerned about running through knots on cedar. Thoughts, suggestions....?
Thanks,
Paul
Just make sure your knots are tight, other wise it will ruin your carving. I try to avoid them when I can but sometimes it adds a nice effect to your carving but plan ahead. I use cedar all the time, it stains beautifully.
Tom Watson
Two CW's and D.C.-Top Mount Insert @ Ringneckblues.com Get the dust out!!
50" X 48" PDJ Pilot Pro CNC http://www.pdjinc.com
Check out my Facebook page for current carvings at http://www.facebook.com/signsinwood
Watsons Wooden Words http://www.signsinwood.com & Messages in Wood http://www.messagesinwood.com/
Paul, Welcome Aboard ! I can't say that enough. I would try and take small carvings passes so I don't stress the bits to breaking point.
Capt Barry