When I put a board in the size I need (12X24) to make a plaque. If i want the machine to route the edge it tells me the board size is wrong. It will measure the board say 11.65X23.40 or something like that and ask me to put new board in.
When I put a board in the size I need (12X24) to make a plaque. If i want the machine to route the edge it tells me the board size is wrong. It will measure the board say 11.65X23.40 or something like that and ask me to put new board in.
Try running the calibrations.
Tell me more, how do I?
Check this thread out.
http://forum.carvewright.com/showthr...ht=calibration