I upgraded to the newest version of the carvewright designer software and every time I try to upload to the card reader it stops responding and then takes forever to respond. Does anyone know what I need to do?
I upgraded to the newest version of the carvewright designer software and every time I try to upload to the card reader it stops responding and then takes forever to respond. Does anyone know what I need to do?
Does the same for me as well, but not on every project, depends on file size or the detail of project that I am uploading. Not sure if there is a fix - How about the software folks chiming in on this one.
Mine does it eveytime when I use centerline text. I'm not quite sure why.
The bigger the file the longer it seems to take. Almost as if it is locked up but if your carving takes a lot of detail then expect to wait. I don't know if center line is big in itself.
Sent from my ADR6300 using Tapatalk 2
Custom Stadium Coin Racks for displaying Military Challenge Coins, GeoCoins and the like- http://www.etsy.com/shop/stadiumdisplays
OR http://shop.ebay.com/stadiumdisplays...&_trksid=p4340
Checking on this with SW eng. today.
Sent from my iPhone using Tapatalk
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
I just updated the software and firm ware and now I'm getting a lot of sensor errors.
Anyone else experiencing this or is it just a coincidence?
Sometimes I'm just totally underwhelmed!
Series "A" Craftsman with Carvetight.