Looking for a pattern for the Navy Command at Sea pin. Yes I saw the one in the pattern store, but looking for one with a little bit better detail and smoothness.
Any help would be appreciated - photo attached
Looking for a pattern for the Navy Command at Sea pin. Yes I saw the one in the pattern store, but looking for one with a little bit better detail and smoothness.
Any help would be appreciated - photo attached
Last edited by chief2007; 10-15-2012 at 07:30 PM.
Bart at one a week was about right for me too.
Chief I emailed it this morning. Hope it works out for you.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Two thumbs up, gave me the detail that I was looking for.
I need to learn how you do it.
Thank you very much
Chief I used Moi3d to draw out the seal. Then extruded the vectors to a height I wanted. Saved it as an OBJ and opened it in ZBrush to sculpt. In Moi, I just gave everything a flat surface at a predetermined height and added the details in ZB.
The new 2d and 3d software should be able to make that pattern. Would take a lot more closed vectors for the details since it does not have the ability to sculpt, or smooth. I do like the puff in the 3d suite. Yet I do not own either of those packages, and Moi3d has more features for less cost. You could also use sculptris a free program instead of ZB for the sculpting. No matter what package you use there is a LARGE/LONG learning curve.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Interested in this pattern as well….available for sale?
Last edited by bjbethke; 03-08-2015 at 12:58 AM.
Using Designer Version 1.187
Donations are always welcomed, thanks – send a check to my PO Box 652
BJB
PO Box 652
Yellville,AR 72687-0652
PM me for my e-mail address.
I like this version better than the original BJ. Always like what you do anyway.