Thanks Tom and Barry, I will post the tomato smile pattern on the site later this week.
Thanks Tom and Barry, I will post the tomato smile pattern on the site later this week.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
That is a great job Eddie!
Thanks Terry. Sharon that is why I posted it, to give you ideas on how it may look. If I were to post this anywhere I would redo it from scratch. Did not like how the mouth came out. It could be much crisper on the edges.
Sharon if you want it, here is the AI file I made to make the pattern. Just un-zip the file.
Last edited by eelamb; 10-07-2012 at 09:43 PM.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Ok...here is what I've come up with so far. Certainly nothing to brag about but it's a learning experience. This is not the end produce that's for sure. I need to figure out how to get rid of the line going through the stem part.
Eddie I will look over your "smile" later this evening, plus I did send you a PM.
Very nice Sharon! Now you are getting the hang of it and it is so much fun!
Tom Watson
Two CW's and D.C.-Top Mount Insert @ Ringneckblues.com Get the dust out!!
50" X 48" PDJ Pilot Pro CNC http://www.pdjinc.com
Check out my Facebook page for current carvings at http://www.facebook.com/signsinwood
Watsons Wooden Words http://www.signsinwood.com & Messages in Wood http://www.messagesinwood.com/
Very nice Sharon, I see I missed something on mine, (a nose ).
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Very good Sharon,
I have been traveling and just now saw your post. Don't have any Design er or graphics programs on this computer. I would so much have liked to help.
Pam