Originally Posted by
WhatDoIKnow
1st post. I am strongly considering buying a Carvewright.
I know this is an open-ended question, but how long does it take to get up and started with some basic carving? I am very computer savy, fairly graphics design savy, but not very woodworking savy.
The project I have in mind is a repeating pattern border around the edge of a flat piece of wood. However, this piece of wood is curvy, not a simple square, rectangle or even a circle. Not sure if the description of the type of project I am wanting to do helps. Could this be accomplished with the included software, or do I need to look at some of the add-on software?
Any help is appreciated. I have already learned quite a bit from this forum.
Thanks.