I've been doing some of my own patterns with some pretty good luck..... But, I can't seem tobe able to make the University of Mich helmet. Any help out there?
Thanks in advance,
Don
I've been doing some of my own patterns with some pretty good luck..... But, I can't seem tobe able to make the University of Mich helmet. Any help out there?
Thanks in advance,
Don
BJB
That is much better than mine but how do you get rid of the surounding box? I need this to be on a16x9.25 ,rotated 90 degrees to the left and at the top of board.
Sorry to be so pickey.
Thanks
Don
I heard that carving a UofM helmet will break your machine. You should carve an MSU helmet instead!
---------------------------------------------------------------
George
Life is short....drink the good wine first!
Got one already
I don't like to post my pattern files. I post the MPC file and a screen image, I adjust the PTN image in a MPC the way I like my carvings to look. You can use the ICON I show in the attached image to extract the patterns. If you would like the complete pattern file (MPC-MPW-PTN, + and - grayscale image and a screen print of the MPC) PM me with an e-maill address I can send that to you. I re-did the pattern so the yellow color does not carve too deep.
That''s the way I save my patterns on CD/DVD's.
Using Designer Version 1.187
Donations are always welcomed, thanks – send a check to my PO Box 652
BJB
PO Box 652
Yellville,AR 72687-0652
PM me for my e-mail address.
I sent the pm to you with another one about some help you did for me in ths past.
thanks again
Don