Last edited by k9smith; 09-27-2012 at 08:42 AM. Reason: spelling
Joe
Can't get it to clean up very well either, but this is what I got.
FBI.mpc
JerryB:.
CarveWright START U Team Member
Using 1.187, Conform, PE/Probe, Centerline.
"Let's start sharing PTNs instead of MPCs so ALL SW versions can view & share"
Thanks I will make a test run and see how it turns out, if not i may go take a cloe up picture of the seal on a sign at our office.
Thanks again guys I appreciate it.
Joe
I cleaned up the image too much! I am working on a pattern, will take a few days before it is done.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
wow that is clean lol
Joe
Actually it is about done already. The ribbon on the outside merging meshes is a real "B". May not ever get it better than shown. The carve size is quite large, 15" x 12" x .4. It would need to be carved large too. I am thinking I may need to do this in 2 patterns, then layer them in ZB to get the sharp edges on the outside.
John you are right. I did find the eagle/shield/arrows at brands of the world, in a eps file which I stripped it out of, but drew the rest in Moi.
Last edited by eelamb; 09-29-2012 at 05:07 PM.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Eddie, Some nice work , my friend.
Capt Barry