Quote Originally Posted by fwharris View Post
On the key board side of the machine, when the bit goes down to touch the plate beside the brass roller. Some have had the bit still spinning and when it lowered it drilled a hole in the plate. If yours is the same then glue a dime on top of the plate for the bit to touch on..
Ok, I will give that a try. In the meantime, I have attached a picture showing where the process stops every time. I notice that it pushes down on the metal plate and then immediately stops with the X Axis error. What is it supposed to be doing at this point? Perhaps if I knew that I could figure out what is wrong.

Thanks again!

David
Click image for larger version.  Name: cw_img.jpg  Views: 66  Size: 76.2 KB  ID: 55643