Z Axis Stall Err. E06-0313. Pres STOP - Please help!

[dhauptman]

Hello,

While trying to cut, I received the following error:

Z Axis Stall Err. E06-0313. Pres STOP

This is very frustrating.

I have reviewed the forum and tried all of the different recommendations - no luck. While it is the same error as others, it seems to happen at a different point. I will explain...

Board is loaded, measured - everything is fine.
1/8 carving bit is installed - everything is fine.
Bit touches down a few times on the wood, bit plate (the one that swings out on the right) - everything is fine.
Bit touches down in the hole to the right of the board (next to the right hand guide) - everything is fine.
Bit touches down on the right hand guide and this is when I get the error every time.

I can press "Stop" and start over but I get the same result. Is there something else I can try? Anything I am missing?

Thanks!
David

[chief2007]

Sometimes the thickness of the board causes the problem. Look at the MPC board dimensions to make sure they are what your board thickness is. Once I had a board that was thinner than the MPC called for and would get the same problem. I corrected the MPC to match the board and smooth sailing from there.


If your board is less that 1/2 inch make sure you have it on a sled.

[dhauptman]

Hello, thanks for the response. I checked the board thickness and it was off. It was 5/8" and MPC was 3/4. I corrected this in MPC but still the same error at the same place.

Any other thoughts?

Thanks again!

David

[Old Salt]

Did the motor start after you put in bit?
Thinking door switch.

[RMarkey]

Sounds to me like you need to use the 'dime' trick. The aux-roller(tracking roller) touch plate may be busted.

The distance between the aux roller and the sliding plate is fixed... about 1/4" difference, and that's how we determine how far the bit looks to touch the sliding plate.

[dhauptman]

Sounds to me like you need to use the 'dime' trick. The aux-roller(tracking roller) touch plate may be busted.

The distance between the aux roller and the sliding plate is fixed... about 1/4" difference, and that's how we determine how far the bit looks to touch the sliding plate.

Can you remind me what the "dime trick" is?

Thanks,
David

[dhauptman]

Did the motor start after you put in bit?
Thinking door switch.

Yes, the motor started fine after the bit was in. Everything is normal except the last "touch" when sensing the board thickness.

[fwharris]

David,

First, is it the 1/16" carving bit?? You stated 1/8"! What chuck are you using?

[dhauptman]

Sorry, I meant 1/8 cutting bit...

[chief2007]

Take a look at the mpc again, try deleting the cut through and set it up again now that you have the proper board thickness.

Maybe attached your project for us to look over as well to see if we might find a problem