Hello everyone!
Looking for a pattern of the state of Wisconsin that I can also use the cut path to carve and cut out for some deer antler mounts.
Thanks for any help!
Tim
Hello everyone!
Looking for a pattern of the state of Wisconsin that I can also use the cut path to carve and cut out for some deer antler mounts.
Thanks for any help!
Tim
Go to this link http://forum.carvewright.com/misc.ph...chments&t=2046
Click on EDIT and FIND. Next type the word state. You will find two entries in alpha order. Select the proper one and you will get the state you wish.
AskBud
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
This may be the same one Bud has referenced, but thought I would pass it on from an earlier forum search...
Wisconsin.ptn
John
www.jdmwoodworks.com
Facebook Page: click FB button on web page
Bessemer, MI (shop location)
Lake Gogebic, MI (where I hang my hat)
"He who wants by the yard, but gives by the inch, should be kicked by the foot"...
If you have problems figuring out how to "cut path" a pattern, what you do is right click on the pattern in your designer page (on the board) and select "outline", you can then get rid of the pattern and the outline shape can have "cut path" added to it.
Hope this helps,
Lawrence