I'm wondering if there is an adjustment for stepover for the CW machine. It's my understanding that it carves
at 128 lines per inch as a default , Is there any way to change this to maybe 64 lines per inch or any other
parameter?
also Is there a way to adjust the z axis "jump" ? when the z axis raises up to go to the next point, Is there
a way to get the "jump" higher?
and finally when you are loading the project onto the card, The differnt carve qualities:
are these determined by the velocity of the Bit? lower quality - higher velocity -
better carve -- lower velocity?
Thanks
FXP