I think someone is yanking someone else's chain! LOL!
I think someone is yanking someone else's chain! LOL!
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
LG sniffing too much walnut sawdust lately? Wear your mask
I think all his fancy finishing may have finished his brain...
JK
My high school physics teacher had one of those beds of nails. He showed it to us and explained how it was done. It was a pretty cool lesson. Don't worry, no teachers were harmed.
Sonuva Nutcracker!
Alex
Carvewright
Hey Lawrence I also was able to order one of the carving bits and this is what I received??? Looks like you better check what you receive.LOL!!
Tom Watson
Two CW's and D.C.-Top Mount Insert @ Ringneckblues.com Get the dust out!!
50" X 48" PDJ Pilot Pro CNC http://www.pdjinc.com
Check out my Facebook page for current carvings at http://www.facebook.com/signsinwood
Watsons Wooden Words http://www.signsinwood.com & Messages in Wood http://www.messagesinwood.com/
Poor Lawrence, ya'll leave him alone. I'm sure he is already biting his nails and worried more about his wife than you guys!!
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
oh no, what am I going to do with several gross of these!
y'all might notice a little runout....
Lawrence
I've used those before. Drilling around corners.
Lawrence,
Can't you just use a hammer or a vice to straighten them out before shipping them. That will minimize the run-out. LOL
That's exactly what happened to my bit when I super glued my kick plate out......... Hey, it was real good glue! Kick plate didn't budge!
JerryB:.
CarveWright START U Team Member
Using 1.187, Conform, PE/Probe, Centerline.
"Let's start sharing PTNs instead of MPCs so ALL SW versions can view & share"
Those work really good in the drill press for making inside radius grooves!