I am unable to achieve any form of accuracy using the cut path tool. In the picture shown notice how accurate the cuts are on the right side of the board, yet how far off they are on the left end. And it becomes progressively worse depending on the distance. This has become a pattern for this machine. The bluegill nose was much more accurate than his tail. The disciples carved the same, with the right disciple only requiring sanding, the left one needed filing. I understand the calibration might be off, but why wouldn't it be the same for raster as cut? Why is it unable to accurately cut what it just carved. Notice that the inside cuts, are all perfect. This is because they were pierced. Any ideas. There was only a bit change, in between. This is a two-sided carve by the way, and the raster carve has perfect correlation between the sides. I have not attempted a calibration yet, are there two calibrations? One for raster, one for vector?! All bearings and belts are tightly adjusted, and all bearings are smooth and tight. It hums like a well oiled machine.
HeartShelfBracket.mpc