Position-correcting router:
http://www.alecrivers.com/positioncorrectingtools/
It's only 2D, but I would think it the concept could be expanded to 3D.
I need this adapted to my hammer so that I stop hitting my fingers!
Position-correcting router:
http://www.alecrivers.com/positioncorrectingtools/
It's only 2D, but I would think it the concept could be expanded to 3D.
I need this adapted to my hammer so that I stop hitting my fingers!
Dick all you need is to find someone willing to hold the nail then you'll stop hitting your fingers.
That does look very interesting. Thanks for sharing.
Thas's too much work. I like to sit back and watch the cnc run.
Morton
I agree with you Morton!
Tom Watson
Two CW's and D.C.-Top Mount Insert @ Ringneckblues.com Get the dust out!!
50" X 48" PDJ Pilot Pro CNC http://www.pdjinc.com
Check out my Facebook page for current carvings at http://www.facebook.com/signsinwood
Watsons Wooden Words http://www.signsinwood.com & Messages in Wood http://www.messagesinwood.com/
That is really cool, but I'm not sure I can hold it steady enough. I will stay with CW. But thanks for posting it is interesting.
Leo Davenport
Enjoy Life Carve Something everyday
I agree about setting back and letting the CW do the work.
Yes to what Morton said, to much work.
Last edited by rcdages; 08-17-2012 at 07:41 AM.
Happy Carving
Robert D.
rcdages
CarveWright START U Team Member.
The mightiest oak in the forest is just a little nut
that held it's ground.
Now for a router that is really cool. I love my CW but for someone who is only into 2-D work that would do just fine. Bet it would do signs really good. Thanks for posting.
CarverJerry
ver. 1.188 Win 7- 64b with 6 GB ram @ 2.8Ghz and dual 1Tb hard drives. Rock Chuck & Ringneck vacuum system hooked up to a Harbor Freight large vacuum. Center line text, conforming vectors.
cool router idea.
Pretty Cool Thingy !!! But i don't need one ...
Mans Quest for knowledge,,, means he'll always find a way !!