Had an z axis stall into the wood 3 hours into carve. Now can't get project to start w check board sensor error. testing sensor and is reading the board fine. reads no board correctly. no drop off when moving Y truck.
Any ideas?
Bruce
Had an z axis stall into the wood 3 hours into carve. Now can't get project to start w check board sensor error. testing sensor and is reading the board fine. reads no board correctly. no drop off when moving Y truck.
Any ideas?
Bruce
White copy Paper Test 156 reading?
Bad FSC Cable.
Bad board Sensor.
Board too dark, not likely since you carved other stuff.
Z Stall??? could be a shorted wire to the board sensor, pinched.
DARN.... 7001 POSTS...
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Whats beyond "senior member"?
** IMPERIAL ** Obie Wood Kanobie Dragon Master ** . "Let the Force be in your Rollers"
JerryB:.
CarveWright START U Team Member
Using 1.187, Conform, PE/Probe, Centerline.
"Let's start sharing PTNs instead of MPCs so ALL SW versions can view & share"
10K = Obsessive Compulsive.... LOL
That is a Impressive Pattern.... Check PM.
AL
Edit... Purchased the pattern from Terry T... Impressive... Simple... But Impressive.... I want to make a 4 x 4 inlay for a printed Ceramic tile. I offer the printed tiles for $20.00 Shipped. Full Color Photos.... I am going to do Navy Ship Patches as part of my Marketing Plan to the Ships, but the possibilities are endless...
Last edited by Digitalwoodshop; 08-20-2012 at 03:27 PM.
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com