Hello..
To start from the beginning a week or so ago while doing a fairly simple care kept getting message something like.. " Continue opereration? ENTER for yes Stop to abort" I reformatted card and did the project with no more problems.
Today on a different project, the carve started off center then the "Continue operation" messages started again. Did the reformat again and thought I should check the sensors because of the off center carve. When I go to options, then check sensors all the individual options flash / scroll through the display, If I watch can see the options.. cover sensor, board sensor etc and can see the values changed when moved but all the time the display is flashing throught all the suboptions and wont stop.
My first thougth is a problem with the ribbon cable / connector to the keypad, but wanted to hear from some of the experts before I start to take it apart.
Thanks
Daniel Smith
Quarry Designs Wood Working