I had to replace the Y-motor mount on a 3-month old machine. Fortunately was under warranty, so just shipping cost incurred thanks to LHR's help. So replaced the motor exactly according to the document "Removing and replacing the Y-motor truck pack". Yet, I am getting a consistent "Y-axis stall, error E05-0303". Not sure why, as I did every step, checked, rechecked and checked again all wires and connections. When I move the head to center position and turn the machine on, it will move all the way to the left (towards the keypad). I start a project, the Z head goes up/down (says homing), then the stall. (see 1st video) Any experts out there that can tell me what I am doing wrong?
UPDATE: Did user tests, x-axis was good, z axis was good, on both y-axis and cut motor tests, head just jerked (see 2nd video)
I have uploaded two videos to show exactly what is happening. Appreciate any assistance or recommendations. Thanks.