That looks great! Nice job.
That looks great! Nice job.
Tom Watson
Two CW's and D.C.-Top Mount Insert @ Ringneckblues.com Get the dust out!!
50" X 48" PDJ Pilot Pro CNC http://www.pdjinc.com
Check out my Facebook page for current carvings at http://www.facebook.com/signsinwood
Watsons Wooden Words http://www.signsinwood.com & Messages in Wood http://www.messagesinwood.com/
Those are some really nice looking carvings and I look forward to your final product.
As an aside, I see you had some head breaking when you put in your brass screws. It helps a LOT if you drill pilot holes, then drive a harder (steel, zinc etc) screw into the pilot hole with a little paraffin on it. Then remove the steel screw and drive the brass screw (with a hand screwdriver). The screw will hold better and you'll never have another breakage. The only big negative I've had is that if the screws are not threaded exactly the same it is difficult to "clock" the screws properly (make the heads all line up the same way) but with phillips drive screws I rarely clock anyway so this is not a deal breaker for me.
All in all though, those are some really nice carvings and I can't wait to see pics of the final table
Lawrence