Need help with a pattern layout

[jaustin]

I made a pattern and need help duplicating it so it will be on the same board twice. end to end with about 1" between each pattern
board length will be 42"

tried duplicating but it gets all out of whack.

Thanks for any help.

John

here is the program file

gun rest.mpc

[ladjr]

I hope this is what you had in mind. The problem was you had mirror function active. Once I remove that I had no problem. Hope this works for you.

[jaustin]

thanks that is perfect.
How do you turn off the mirror function?

[AskBud]

thanks that is perfect.
How do you turn off the mirror function?

Leo probably deleted the mirror, and used Copy & Paste instead.

Be advised that Leo also has assigned the 3/16 cutting bit!
AskBud

[ladjr]

To turn off the mirror simply highlight the item and then click on the mirror button


Leo

[jaustin]

thanks

John

[SteveNelson46]

John

I did this with the new copy offset tool. I don't know if it's what you are looking for but, I had a lot of fun doing it for the experience!

[ladjr]

John

I did this with the new copy offset tool. I don't know if it's what you are looking for but, I had a lot of fun doing it for the experience!

Steve

That is exactly what I did below

[SteveNelson46]

Leo

I didn't look at your post before posting mine. I guess I just re-invented the wheel.

[ladjr]

Leo

I didn't look at your post before posting mine. I guess I just re-invented the wheel.

Don't worry about it. I don't know how many times I have done the same thing