Thanks Bud...I am thinking it is just focused on the cover switch...I think one of them or both need replacing
Thanks Bud...I am thinking it is just focused on the cover switch...I think one of them or both need replacing
Upside down card?
I would unplug the machine and remove the bottom and inspect the Computer where the Card Plugs in.... The Computer has MALE pins that could have been bent....
If you can get past the error do sensor checks looking for problems.
Lets hope it is not a Vacuum Problem with static.
Good Luck,
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
The cover switch/sensor is the one on the keyboard side. I would begin by doing a sensor check. If it operates well when you activate it with a pencil or small screwdriver, then your problem may just be its position or how the cover depresses it (a minor adjustment or a loose screw on the switch or cover hinge area.
If the sensor check is bad, first check for a loose wire.
AskBud
Last edited by AskBud; 07-22-2012 at 08:34 PM.
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
Checked the switches and there is a loose wire on the one (keyboard side) they look in rough condition as they sit. Will probably replace it just for preventative maintenance.
Thanks Al will give that a shot
I've never seen that error actually occur, and I won't try to describe what it entails.
However, it involves navigating through projects on your card, so reformatting your card may solve the problem.
Thanks Metallus, will use a different card first to see if that makes a difference