Hi,
I have some simple scroll saw patterns I wish to use with the carvewright. I can cut the patterns out in a couple of minutes with the scroll saw. I am able to scan the images on the copier and forward them to my computer. I was then able to pull it up in the pattern editor. My problem is that when I went to cut it out, it used the 1/16 carving bit. This took over 4 hours to cut out. What I want it to do is cut the outline out with a 1/8 cutter bit. This will give me straight edges instead of a taper from the carving bit. Basically I want to Cut out some simple patterns in 3/4" wood. I am missing a step somewhere.

Thanks,
Marcus