First carve after getting the machine back from LHR for the CT and maintenance upgrades and first time using since the conference. Loaded a piece of MDF 10x16X 3/4 and tried to cut a 6X9 carve region to create a sled for some 1/4 Corian. Machine fired up and ran but my size didnt' turn out right (operator error) so I tried another and this time after measuring the board and the bit touching the bit plate, I got the "Slipped" check Y belt followed by a Y/Z Homing fault. I am running the latest version of Designer along with a fresh firmware update. Any ideas guys?
By the way Floyd if you read this your Dust Insert is great!!

Mark