I need a patern of a Dobrow (i think that is how it is spelled) It's a type of Guitar. Thanks
Junior Member
lookin
I need a patern of a Dobrow (i think that is how it is spelled) It's a type of Guitar. Thanks
Junior Member
Dobro pattern
[
How about this?
TTACH]54622[/ATTACH]
In Memoriam
I'm not a musician, but isn't the metal circle supposed to be bowed out, rather than in?Originally Posted by mercer57
[
How about this?
TTACH]54622[/ATTACH]
AskBud
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
Junior Member
Thanks mercer57. And yes on out.
Senior Member
woodrat will this one work for you.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Junior Member
Can someone clean this picture up good enough the carve?
Senior Member
Hay! Where did you get that picture of my relatives???
Junior Member
Hello Sharon
I didn't know that we were related. Yhis is a picture of my brother and myself LOL
Senior Member
Stan, I tried but the image is just too small. I can clean it up but there again it will be really too small to make a pattern from.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Senior Member
I don't know guys.... my wife says that is definately me..... she sees that hard head that's got a few 2x4 dents in it so.... she says it's got to be me!
JerryB:.
CarveWright START U Team Member
Using 1.187, Conform, PE/Probe, Centerline.
"Let's start sharing PTNs instead of MPCs so ALL SW versions can view & share"
Posting Permissions
Reply With Quote