Ok Ive just about realized that Ive bought a 1600 dollar money maker for LHR. This machine is not even a month old and Ive had to replace belts cause I was told by techs to run it after getting head pressure down to 95 but didnt know that I should have checked it several times. Figured the tech would know. Anyway the board messed up the belts and come to find out the pressure was increasing everytime I loaded a project, was all the way up to 200 lbs. Had to replace belts and reset the heads. Oh well tough lesson. Then the bit checker started messing up. Now the board sensor is messed up and upon taking it off, the lenses are full of saw dust and I clean this machine after every use and clean it meticulously. Why is this not a sealed unit since so many people are having the same problem. Oh yeah, they can continue to sell these if they keep messing up. So, am I going to have to buy a new board sensor every monthm no matter how clean i keep my machine? This really is ridiculous to have so many problem from a new machine that is taken care of.