Nothing comes up on my LCD display. ?? I installed a new ribbon wire. Still nothing. Anyone? please.
Nothing comes up on my LCD display. ?? I installed a new ribbon wire. Still nothing. Anyone? please.
Jack of all trades ,master of none, but if you got a job, I'll git-er-done.
http://theswamper.tripod.com/
Jackssib1
Make sure the data card is pushed all the way in before turning the machine on. Also, try formatting the data card or use a different one.
Last edited by SteveNelson46; 06-24-2012 at 12:30 PM.
Steve
I hope you didn't smoke the computer.
Sent from my Droid using Tapatalk 2.
Custom Stadium Coin Racks for displaying Military Challenge Coins, GeoCoins and the like- http://www.etsy.com/shop/stadiumdisplays
OR http://shop.ebay.com/stadiumdisplays...&_trksid=p4340
Try ajusting the contrast control on the display. Semper Fi .
Capt Barry
Jack of all trades ,master of none, but if you got a job, I'll git-er-done.
http://theswamper.tripod.com/
Sounds like the controller. Do you vacuum out your machine with a shop vac?
Sent from my Droid using Tapatalk 2.
Custom Stadium Coin Racks for displaying Military Challenge Coins, GeoCoins and the like- http://www.etsy.com/shop/stadiumdisplays
OR http://shop.ebay.com/stadiumdisplays...&_trksid=p4340
Any bent pins on the Computer jack for the Card?
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
I had this problem on a machine at a high school shop. I found the ribbon wire pinched.You could have a bad power supply.Un plug your machine,then move the truck back in forth. Then plug in your machine and turn it on . If the power supply is working you should feel a drag.There is 2 voltages coming out of the power supply 1 for cut motor and 1 lower voltage for the screen. Ross
The "Other Power Supply Trick"... Is to remove the Muffler and lay the machine on it's back, the Muffler Side. with the power on and watch the LCD Display.... I learned in 2007 that when the L2 Coil on the Power Supply snaps off, it is usually the outer lead. By laying the machine on it's back GRAVITY presses the broken L2 Wire back into the hole and the LCD comes back on... Before you start... Put the LCD Dimmer or contrast in the middle of it's travel.
So this could really be a L2 Coil problem especially if it is a "A" version since you joined in 2008. QC Vibration caused it.... Do you have a QC?
Good Luck,
Let us know,
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Al
You amaze me with your knowledge of the machine and your constant help to us less knowledgeable.
Last edited by ladjr; 06-25-2012 at 12:46 PM.
Leo Davenport
Enjoy Life Carve Something everyday